Skip to main content

mechooks

Search This Blog

About

Posted by Ritik Raina

Get link
Facebook
X
Pinterest
Email
Other Apps

welcome to www.theindianhustlers.in - a blog that provides free books to read.

YOU LEARN WHEN YOU KNOW.

Get link
Facebook
X
Pinterest
Email
Other Apps

Comments

Post a Comment

If you have any doubts let me know.

Popular Posts

Carbon Steels & Special Low-Carbon Steels

Carbon Steels & Special Low-Carbon Steels Carbon steels (also called plain-carbon steels) constitute a family of iron–carbon–manganese alloys. In the SAE/AISI system, the carbon steels are classified as follows: •Nonresulfurized carbon steels 10xx series •Resulfurized steels 11xx series •Rephosphorized and resulfurized steels 12xx series •High-manganese carbon steels 15xx series A four-digit SAE/AISI number is used to classify the carbon steels with the first two digits being the series code and the last two digits being the nominal carbon content in points of carbon (1 point = 0.01% C). For example, SAE/AISI 1020 steel is a carbon steel containing 0.20% C (actually 0.18–0.22% C). The chemical composition limits for the above SAE/AISI 10xx series of carbon steels for semifinished products, forgings, hot- and cold-finished bars, wire, rods, and tubing are listed in SAE Materials Standards Manual (SAE HS-30, 1996). There are slight compositional variations for struct...

HEAT TREATMENT OF STEEL

HEAT TREATMENT OF STEEL One of the very important characteristics of steel is the ability to alter the microstructure through heat treatment. As seen in the previous sections, many different microstructural constituents can be produced. Each constituent imparts a particular set of properties to the final product. The common types of heat treatment are listed below: Annealing (Full Annealing) One of the most common heat treatments for steel is anneal- ing. It is used to soften steel and to improve ductility. In this process, the steel is heated into the lower regions of the austenite-phase field and slow cooled to room temperature. The resulting microstructure consists of coarse ferrite or coarse ferrite plus pearlite, depending upon carbon and alloy content of the steel. Normalizing Steel is normalized by heating into the austenite-phase field at temperatures somewhat higher than those used by annealing followed by air cooling. Many steels are normalized to establish ...

IRON & STEEL MANUFACTURE

IRON & STEEL MANUFACTURE In most of the world, steel is manufactured by integrated steel facilities that produce steel from basic raw materials, i.e., iron ore, coke, and limestone. However, the fastest growing segment of the steel industry is the “minimill” that melts steel scrap as the raw material. Both types of facilities produce a wide variety of steel forms, including sheet, plate, structural, railroad rail, and bar products. Ironmaking When making steel from iron ore, a blast furnace chemically reduces the ore (iron oxide) with carbon in the form of coke. Coke is a spongelike carbon mass that is produced from coal by heating the coal to expel the organic matter and gases. Limestone (calcium carbonate) is added as a flux for easier melting and slag formation. The slag, which floats atop the molten iron, absorbs many of the unwanted impurities. The blast furnace is essentially a tall hollow cylindrical structure with a steel outer shell lined on th...

Powered by Blogger

Theme images by mammamaart